Proportioning Valve

[Jelly]

Replaced the proportioning valve on 72 Mach 1, it's leaking at the electrical connection.  Not sure if the pigtail plug in is allowing it to leak or the plastic electrical connection itself is leaking.  Is there a place to get the plug in electrical connection?

Thanks in advance for any assistance you folks could provide.

V/R
Jim

[JTS71 Mach1]

Not that I know of I believe you will need to replace the whole valve. Hope it helps

JTS

[JackWagon3]

Just get a new switch. The plastic connector won’t leak, just the switch will. I had to replace mine recently

[Jelly]

Just get a new switch. The plastic connector won’t leak, just the switch will. I had to replace mine recently

So the plastic electrical connection that threads into the distribution block was leaking, replaced it, but the wiring connection seems to be leaking...Is that what you were referring to as the switch?

[Jelly]

Just get a new switch. The plastic connector won’t leak, just the switch will. I had to replace mine recently

Where were you able to find it?

[JackWagon3]

I think I jinxed myself. Mine just started leaking again too. Ecklers and CJ pony parts has them though.

[Jelly]

I think I jinxed myself. Mine just started leaking again too. Ecklers and CJ pony parts has them though.

So that is the "electrical connection", and it is leaking, when you say switch what are you referring to.....

[JackWagon3]

Yes that is what you need to replace.