Folks,
My motor is nearly finished - I was intending to fit a Gilmer belt system.
Is it possible to run a Gilmer system with power steering and air conditioning?
I have found plenty of Gilmers with an extra groove on the lower pulley for the p/steering - but, no one offers a set up for air con.
If you guys say it's not possible, then I'll stay stock.
OK guys, I've just ordered a Gilmer belt system for my 351C.
The bottom pulley is being custom made as I type this.
On either side of the 1 1/2" main belt the workshop is machining in a v-belt groove. The rear belt groove is for the power steering and the front belt groove is to drive the air con.
I will have to re-locate the air con compressor forwards about 1/2", but I don't expect this to be a major hassle.
(11-08-2012, 07:06 AM)Bluemach Wrote: OK guys, I've just ordered a Gilmer belt system for my 351C.
The bottom pulley is being custom made as I type this.
On either side of the 1 1/2" main belt the workshop is machining in a v-belt groove. The rear belt groove is for the power steering and the front belt groove is to drive the air con.
I will have to re-locate the air con compressor forwards about 1/2", but I don't expect this to be a major hassle.
My engine should be finished early next week.
regards,
Rod A
Please remember to post pics when done.
Sounds awesome.
This is it.
30 thou oversize / Holley Ultra Street Avenger / HEI Dissy / block was decked 80 thou just to get them even.
Major head work / Hi Comp pistons / Mutha Thumpa cam / Titanium push rods / Crane roller rockers / Hi flow oil pump / Enhanced internal oil galleries + external oil line to rear of block / 4 MPA crank [?] / ARP studs throught out / Double row timing chain / 3 row alloy radiator + 2x14" thermo fans / 100 amp alternator / 3hp starter motor / 4V headers.