09-04-2021, 12:20 AM
My FMX kickdown works but if I floor it in D it only holds onto 2nd until 4,500 before it changes up, I've screwed the module ( blue one) screw in a half a turn to see if it changed but it didn't, is 4,500 too low, I was expecting 5,500 or so.
From what I've read it could be the trans governor but to be honest I dont want to take the back off to see if it's sticky.
What does moving the screw in the modulator do?
I've had the two rubber vacuum modulator pipes off to check they are not leaking or collapsed but they seem fine.
on the opposite side of the box to the modulator is a steel pipe pointing down with a witness mark where I guess a rubber pipe was once, is it just a drain pipe or should It connect up to something
I know FMX boxes are not popular but if they are as bulletproof as people say that is worth far more to me over here as access to C4 or C6 boxes is not easy here so I will keep it until I or it dies.
Thanks for any help
From what I've read it could be the trans governor but to be honest I dont want to take the back off to see if it's sticky.
What does moving the screw in the modulator do?
I've had the two rubber vacuum modulator pipes off to check they are not leaking or collapsed but they seem fine.
on the opposite side of the box to the modulator is a steel pipe pointing down with a witness mark where I guess a rubber pipe was once, is it just a drain pipe or should It connect up to something
I know FMX boxes are not popular but if they are as bulletproof as people say that is worth far more to me over here as access to C4 or C6 boxes is not easy here so I will keep it until I or it dies.
Thanks for any help