07-12-2018, 12:10 PM
(07-01-2018, 04:28 PM)1969_Mach1 Wrote: Nice work. If my 69 Mach1 had rear disk brakes I'd consider the conversion. Makes good use of those decorative side scoops.
I spend a lot of time using 3D solid modeling CAD software for my work but never 3D printing. What is the strength of plastic parts made using 3D printing compared to some type of molded part?
The original model was made with a 3D printer then they were cast in a rubber mold. The vents are made of Thermal plastic, it is strong and holds up fine. The 3D printed one would fall apart under pressure.