Final Upgrade
#1
I finally got the last upgrade completed. My FMX died and instead of a rebuild or AOD, I went with a 5speed TKO. (Now cosmetic stuff)
Car was a 3512V,FMX 3.0 standard diff ,a/c, p/s
now 393 Stroker roller cam,1.7 rockers,750DP,power 4 wheel disk brakes, rack and pinion steering,3.50 trutrac, 31 spline moser axles, hydraulic clutch,5 speed TKO-600.
Reply
#2
I like the idea of switching the automatic for a standard - just makes sense.

My car has the pedals and I have a five speed set aside.

What hydraulic clutch setup did you use?
Reply
#3
Man after my own heart, built it the way he wanted it. Now go out and drive it like you stole it! Or as my buddy Bob Kennedy would say "I'll Mail in My License Now, and Go Have Some Fun!" JTS 71 Mach1
Reply
#4
I got the kit from modern drivelines. Clutch is a Kevlar 10.5", hyd clutch was LF series type 3. I had an issue with my yoke. it is hollow and leaked tranny oil. Just got it back again from the shop, welded the hole and balanced it again( had to be shortened 2.5").
I am going to have fun driving it now!!!!!!
Reply
#5
Nice upgrades and excellent choices!
Reply
#6
(01-14-2016, 06:07 AM)davej Wrote: I got the kit from modern drivelines. Clutch is a Kevlar 10.5", hyd clutch was LF series type 3.

Good to know - thanks for sharing.

Now go out nd enjoy the drive!
Reply
#7
I'm curious;
I just put a 5 speed Tremec in my sons 67 mustang hooked to a brand new 340 HP (347) stroker engine.
We had a new Detroit Locker installed with 3:80 gears.
Now cruising down the Interstate at 75mph the fifth gear is only pulling about 2,100 or so RPM. At a dead stop, it will easily lay rubber tracks down the street in three gears just with my first few tests.
So my question is:

Are your gears deep enough at 350?

I'm thinking that my gears should be 3:90 instead of the 3:80 to put fifth gear slightly higher into the power band.
What are your thoughts?
Have you road tested your car yet with that set up?
My sons fifth gear just seems a little too gutless.

Comments??????
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Brakes upgrade front & rear mymachone 10 3,948 01-14-2018, 04:31 AM
Last Post: mymachone
  Seat Upgrade pics OlBlooey 4 3,776 02-24-2017, 11:27 AM
Last Post: Steven Harris
  Seat Upgrade OlBlooey 0 1,639 02-20-2017, 10:26 AM
Last Post: OlBlooey
  Seat Upgrade OlBlooey 0 1,675 02-20-2017, 10:14 AM
Last Post: OlBlooey

Forum Jump:


Users browsing this thread: 1 Guest(s)
[-]
Latest Threads
hdshadpar
Last Post: Steven Harris
02-17-2019 02:25 PM
» Replies: 3
» Views: 151
UK Mach1
Last Post: Steven Harris
02-17-2019 02:16 PM
» Replies: 2
» Views: 173
1971 Boss 351
Last Post: Steven Harris
02-17-2019 02:10 PM
» Replies: 4
» Views: 159
Vin Decoder
Last Post: JTS71 Mach1
02-16-2019 08:53 AM
» Replies: 8
» Views: 5363
Bonnet latches
Last Post: JTS71 Mach1
02-13-2019 02:11 PM
» Replies: 2
» Views: 190
Vin decoder
Last Post: Oztrailer
02-11-2019 07:56 PM
» Replies: 1
» Views: 220
Ignition Timing
Last Post: JTS71 Mach1
02-10-2019 09:37 AM
» Replies: 23
» Views: 3953
"Jacobra"
Last Post: JTS71 Mach1
02-10-2019 09:18 AM
» Replies: 62
» Views: 14638
New Member
Last Post: Mustangmike
02-07-2019 09:25 PM
» Replies: 8
» Views: 533
Fuse Panel on my ‘69
Last Post: 1969_Mach1
02-06-2019 06:28 PM
» Replies: 3
» Views: 292
66 Fairlane Project
Last Post: Mustangmike
02-03-2019 10:42 PM
» Replies: 542
» Views: 158260
1973 Mach 1 parts
Last Post: Steven Harris
02-03-2019 06:37 AM
» Replies: 5
» Views: 560
Newbie - Just brought this baby home
Last Post: Steven Harris
02-03-2019 06:33 AM
» Replies: 5
» Views: 607
This One's Funny!
Last Post: JTS71 Mach1
02-01-2019 10:08 AM
» Replies: 2
» Views: 384
Dash ignition light?
Last Post: JTS71 Mach1
01-21-2019 10:37 AM
» Replies: 3
» Views: 792
New addition to the stable..
Last Post: Steven Harris
01-16-2019 01:26 PM
» Replies: 5
» Views: 926
Alternator Light Won't go off
Last Post: 1969_Mach1
01-06-2019 05:35 AM
» Replies: 13
» Views: 2183
Merry Christmas 2018
Last Post: Steven Harris
12-30-2018 12:56 PM
» Replies: 10
» Views: 1221
Led lights not all that good.
Last Post: John
12-28-2018 02:12 PM
» Replies: 24
» Views: 9432
"70 Mach 1 Fuel Line Routing
Last Post: 1969_Mach1
12-28-2018 06:07 AM
» Replies: 1
» Views: 618

>