1969 mustang wiring diagram
#1
chassis diagram


Attached Files
.pdf   1969 mustang diagram chassis.pdf (Size: 192.65 KB / Downloads: 157)
Reply
#2
hope this helps me I'm working on a 69 mach 1 just put a new wiring harness in from firewall out, when i turn the key to "on" position it tries to crank....someone has been doing some "homemade" wiring on the car so who knows what I'll get into. any comments and/or suggestions would be a help. Car was wrecked on the right front real bad, had to replace from right lower firewall out and rails on both sides, new aprons and rad support.
Reply
#3
(01-19-2011, 11:26 AM)CHRIS_b Wrote: hope this helps me I'm working on a 69 mach 1 just put a new wiring harness in from firewall out, when i turn the key to "on" position it tries to crank....someone has been doing some "homemade" wiring on the car so who knows what I'll get into. any comments and/or suggestions would be a help. Car was wrecked on the right front real bad, had to replace from right lower firewall out and rails on both sides, new aprons and rad support.

Chris can you be more specific what do you mean it trys to crank? it clicks or it turns over dont start?If it just clicks coul be ground or solenoid maybe.Turns not start possibly no spark.possible wires to coil,distributor,maybe from ignition switch.need a little more info.
Reply
#4
If the engine is cranking, i.e. the cooling fan is turning when you turn the ignition key, fuel can be an issue too besides getting a spark. These old cars do not have electric fuel pumps and are harder to start. You usually need to pump the gas pedal several times to get the gas flowing. Make sure the automatic choke on the carb is closed too. Good luck.
Reply
#5
Hi Jim,

Many thanks for the diagram i'll give this ago to see how i get on. most of the wiring seems ok its just some minor problems i need to fix.

Regards,

Tony
Reply
#6
(08-23-2011, 04:21 AM)Leadfoot Tony Wrote: Hi Jim,

Many thanks for the diagram i'll give this ago to see how i get on. most of the wiring seems ok its just some minor problems i need to fix.

Regards,

Tony

No problem Tony good luck on your problems.Be sure to check your grounds.Seems like alot of electrical issues start at bad grounds.
Reply
#7
(08-24-2011, 08:27 PM)1969jimmach Wrote:
(08-23-2011, 04:21 AM)Leadfoot Tony Wrote: Hi Jim,

Many thanks for the diagram i'll give this ago to see how i get on. most of the wiring seems ok its just some minor problems i need to fix.

Regards,

Tony

No problem Tony good luck on your problems.Be sure to check your grounds.Seems like alot of electrical issues start at bad grounds.

Looks good to me also, RATS, yes rats got under the hood and enjoyed the taste of some of my wires.
Reply
#8
Welcome Bart.

Yes - rats, mice and various other critters can certainly put the hurt on car wiring. I bought a parts car that had the carb full of dirt from field mice and they had eaten all wires including the plug wires.
Reply
#9
(01-09-2012, 05:29 AM)bartmcneill Wrote:
(08-24-2011, 08:27 PM)1969jimmach Wrote:
(08-23-2011, 04:21 AM)Leadfoot Tony Wrote: Hi Jim,

Many thanks for the diagram i'll give this ago to see how i get on. most of the wiring seems ok its just some minor problems i need to fix.

Regards,

Tony

No problem Tony good luck on your problems.Be sure to check your grounds.Seems like alot of electrical issues start at bad grounds.

Looks good to me also, RATS, yes rats got under the hood and enjoyed the taste of some of my wires.

Yeah you think they are bad in cars you should work on farm equipment like I do grain really attracts them. good luck and welcome.
Reply
#10
Hope these diagrams help with my many problems
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Scott Drake L.E.D. Dash Upgrade from Sacramento Mustang Mach 1 Club 0 209 10-07-2018, 12:02 PM
Last Post: Mach 1 Club
  1969 Mustang Mach1 clock and dash gauge repair Mach 1 Club 1 220 10-04-2018, 09:32 AM
Last Post: JTS71 Mach1
  1971 mustang diagram 1969jimmach 1 4,855 07-03-2014, 10:07 AM
Last Post: jomama599
  1972 mustang diagram 1969jimmach 10 12,884 05-28-2014, 01:32 AM
Last Post: Steven Harris
  How To Replace '65-'73 Mustang Ignition Switches Mach 1 Club 0 2,580 01-10-2014, 02:46 PM
Last Post: Mach 1 Club
  Classic Mustang Interval Wiper Switch Install - How To Install Interval Wipers Mach 1 Club 0 2,595 01-10-2014, 02:42 PM
Last Post: Mach 1 Club
  72/'73 MUSTANG CHASSIS WIRING Mach 1 Club 1 2,810 12-23-2011, 03:07 AM
Last Post: Steven Harris
  Shedding The Light 1969 1970 Mustangs Mach 1 Club 0 2,328 12-20-2011, 04:55 AM
Last Post: Mach 1 Club
  Best Battery for your Mustang Mach 1 Club 7 7,515 09-16-2011, 03:14 AM
Last Post: Mach1Guy
  CONVERT 2 SPD MUSTANG WIPERS TO INTERMITTENT Mach 1 Club 4 5,328 07-08-2011, 10:51 AM
Last Post: Rare Pony

Forum Jump:


Users browsing this thread: 1 Guest(s)
[-]
Latest Threads
Pictures and some info from a new guy
Last Post: John
Today 08:25 AM
» Replies: 16
» Views: 237
How not to Handle A DUI Checkpoint?!?!
Last Post: Vanbens91
11-14-2018 07:22 PM
» Replies: 1
» Views: 1925
Led lights not all that good.
Last Post: Mustangmike
11-14-2018 09:44 AM
» Replies: 20
» Views: 4669
1972 Mach1 rear fold down seat problems....
Last Post: John
11-13-2018 03:04 AM
» Replies: 10
» Views: 299
1972 Mach1 parts
Last Post: John
11-10-2018 10:31 AM
» Replies: 0
» Views: 80
COIL SPRINGS
Last Post: 1969_Mach1
11-08-2018 09:43 AM
» Replies: 5
» Views: 163
"Jacobra"
Last Post: JTS71 Mach1
11-07-2018 02:27 PM
» Replies: 50
» Views: 6636
My newest 1970 Mustang Fastback 302
Last Post: Mach 1 Club
11-07-2018 01:52 PM
» Replies: 20
» Views: 994
SITE UPDATE
Last Post: Oztrailer
10-30-2018 07:14 PM
» Replies: 9
» Views: 558
50 Best Vintage Mustang Bolt-Ons
Last Post: Steven Harris
10-30-2018 03:35 PM
» Replies: 1
» Views: 240
New member
Last Post: Steven Harris
10-30-2018 03:27 PM
» Replies: 2
» Views: 263
Installing Factory gauges in a '71-'73 M...
Last Post: Mach 1 Club
10-28-2018 03:19 AM
» Replies: 3
» Views: 438
Ford Mustang: An epic 50 year journey
Last Post: Mach 1 Club
10-26-2018 01:32 PM
» Replies: 0
» Views: 189
66 Fairlane Project
Last Post: Mustangmike
10-16-2018 07:30 PM
» Replies: 518
» Views: 98981
Mustang gets SPLIT IN HALF during street...
Last Post: JTS71 Mach1
10-14-2018 11:20 AM
» Replies: 6
» Views: 566
28 Classic Mustang Restoration Tips You ...
Last Post: Mach 1 Club
10-13-2018 03:44 PM
» Replies: 0
» Views: 261
Once-in-a-Lifetime Find: 1969 Ford Musta...
Last Post: JTS71 Mach1
10-13-2018 01:42 PM
» Replies: 1
» Views: 227
How to Repair Rust on Your Car Without W...
Last Post: JTS71 Mach1
10-12-2018 10:48 AM
» Replies: 6
» Views: 416
What happened?
Last Post: Steven Harris
10-12-2018 09:19 AM
» Replies: 5
» Views: 443
New Member
Last Post: Steven Harris
10-12-2018 09:16 AM
» Replies: 5
» Views: 556

>