08-25-2015, 08:31 AM
Last weekend I did a change of coil spring saddles, while there changed calipers and break fluid.
I used internal coil compressor tool but no pipe needed, I write a DIY on Garage section to explain process, with no risk and low effort.
I bleed break lines and motor start, It was off since February, I installed a in line filter just before carburetor and routed line not in front of Carb but behind, I try to solve fuel leak on Carb bronze inlet filter metal gasket (Holley Carb), from inspecting seems that I have different gaskets for main and secondary, may be this is the problem. But runs like a babe, after 3 attempts of starting It does with no hesitation, just key turning.
Mario.
I used internal coil compressor tool but no pipe needed, I write a DIY on Garage section to explain process, with no risk and low effort.
I bleed break lines and motor start, It was off since February, I installed a in line filter just before carburetor and routed line not in front of Carb but behind, I try to solve fuel leak on Carb bronze inlet filter metal gasket (Holley Carb), from inspecting seems that I have different gaskets for main and secondary, may be this is the problem. But runs like a babe, after 3 attempts of starting It does with no hesitation, just key turning.
Mario.