Fuse Panel on my ‘69 - Printable Version +- Mach 1 Club (https://mach1club.com) +-- Forum: Mustang Mach 1 Forums (https://mach1club.com/forumdisplay.php?fid=5) +--- Forum: 1969 - 1970 MUSTANG MACH 1 FORUMS (https://mach1club.com/forumdisplay.php?fid=6) +---- Forum: Electrical (https://mach1club.com/forumdisplay.php?fid=28) +---- Thread: Fuse Panel on my ‘69 (/showthread.php?tid=6851) |
Fuse Panel on my ‘69 - Charles Terry - 02-06-2019 Just bought a ‘69 and have a few electrical issues. I checked out the fuses and found them all good except for the short stubby 4A that controls instrument lamps, clock, etc. I don’t have power on either end of this fuse so it is not simply a bad fuse. Anyone run into a similar problem and, if so, what was your solution. Could this problem just be a bad fuse panel? Thanks RE: Fuse Panel on my ‘69 - bob.harlan - 02-06-2019 One possibility is dirty contacts in the light switch. The instrument lamps are controlled by a rheostat that maybe dirty. Try rotating the switch knob back and forth several times. That worked on mine. RE: Fuse Panel on my ‘69 - Charles Terry - 02-06-2019 (02-06-2019, 06:18 AM)bob.harlan Wrote: One possibility is dirty contacts in the light switch. The instrument lamps are controlled by a rheostat that maybe dirty. Try rotating the switch knob back and forth several times. That worked on mine. Tried that but did not work for me. Tomorrow I will make up a jumper wire with an in-line fuse and see what I can figure out. Thanks for the suggestion! RE: Fuse Panel on my ‘69 - 1969_Mach1 - 02-06-2019 Just to confirm, you did have the ignition key in the run position while you were checking the fuses? |